|
|
 |
|
 |
EICSB116 - Reverse Light Switch Install
| |
|
|
Installing Reverse Light Switch Into Transmission
Installation can be accomplished from under the vehicle, but it is considerably easier if you remove the transmission floor plate and install from above.
|
|
|
Remove the plug above and to the right of the transmission output shaft.
|
|
|
Remove the old style plunger. I have seen this plunger slide out very easily. I have also seen this plunger need to be removed with a small slide hammer! If the plunger is worn it may require removal with a pair of visegrips. Verify that the circlip is still installed on the old plunger.
|
|
|
Install the new plunger supplied in the kit. The "flared" end is out and will engage the switch. Screw in the switch making sure to use the new crush washer supplied in the kit. Do not overtighten, just good and snug.
|
|
|
Install the wiring plug. Again snug down, do not overtighten.
|
|
|
Wiring Overview
Simple as can be. Run (+) to one of the 2 wires on the wiring plug. The other lead runs to the back of the vehicle where it "T"s and goes to each tail light.
We prefer to pick up the (+) from the auxilliary power box behind the passenger seat (if equipped) as this gives us the ability to engage the reverse gear and use the lights for loading, etc., without the ignition switch having to be on. Install a fusible link on the (+) wire coming into the switch.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
 |
| 0 Items: |
$0.00 |
| Shipping: |
$0.00 |
| Total: |
$0.00 |
|
 |
 |
|
Pinzgauer 710/712 Parts Manual
|
|
Fuel Tank Sending Unit with Gasket
|
|
Best of Unimog 2009 Calendar
|
|
|
|
)
)
)
)
)
